INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 27 of 68
At the bottom of the main screen and each screen
described below, there will be coloured rectangles
(
Fig. 40 ref. B
) located above the icons of identifica-
tion function (
Fig. 40 ref. C
). These functions are
activated by pressing the appropriate coloured button
on the push-button panel (
Fig. 39A ref. 9
).
Only for VARGM19TS355
All the push-buttons on the lower bar (
B
) can be se-
lected by touch.
For both versions
Press the button (
Fig. 40 ref. 3
) to display a second
page where you can access the “Technical assistance”
menu and the “Run-out” menu (see
Fig. 41
).
Fig. 41
KEY
1 – User menu
2 – Run-out menu (visible only if the machine is fit
or if the Run-out device is enabled)
3 – Return to previous page
1
2
3
In order to turn off the machine, simply press the "OFF"
switch (
Fig. 25 ref. 1
).
W H E N T H E E Q U I P M E N T I S
TURNED OFF LOSES ALL THE
M E A S U R E M E N T S A N D T H E
STORED DATA (SIZE, SPINS, US-
ERS, ETC ...). AT RESTARTING,
PRESSING THE BUTTON
(IN
THE CASE HAVE NOT YET BEEN
STORED ON THE NEW MEASURES
AFTER THE SWITCHING ON), THE
MACHINE DOES NOT PERFORM
ANY OPERATION.
14.2 Balancing programs setting
The setting of the balancing programs can be per-
formed in two ways:
- through the gauge arm (rapid setting);
- through “Measurement being acquired” screen, ap-
pearing when the
button is pressed (
Fig. 40
ref. 1
).
The setting modes are completely different even if
they allow to reach the same result (but with different
times).
1297-M008-4_B
LIBRAK355 - LIBRAK355P - LIBRAK355S - LIBRAK355PS - LIBRAK355WS - LIBRAK355PWS
