Getting to know your Micro System
You’ll be up and running in no time
Getting to know your Micro System
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Installing the batteries in the remote control
1.
Press the small tab at the bottom of the battery compartment upwards as shown. And
remove the battery compartment cover
(Fig 5)
2.
Insert two AAA/ LR3 battery taking care that the battery direction matches the printed
directions inside the battery compartment.
(Fig 6)
3.
Replace the battery compartment cover.
Dispose of used batteries with regards to the recycling regulations in your area. Do
NOT short circuit batteries or throw them into water, the general rubbish or in a fire.
Weak batteries can leak and damage the remote control. Replace them in good time.
Connecting the mains power cable
1.
Connect the mains plug to a wall outlet and switch on.
2.
Press the STANDBY button on the micro system or remote control to wake from
standby.
Fig 5.
Fig 6.
Summary of Contents for CMC1113DABBT
