1/31/02
8
4
.
7. Put your ohm meter (multi-meter) probes on the (2)Two silver resistance measuring pads through the opening shown in
the drawing – making good contact with these (2)Two silver pads on the board
. (See drawing on page 1)
. Or put your
(2)Two probes into the (2)Two holes on the bottom of the case making contact with the underside of the silver pads.
Either contact point method will work.
8. With the probes held firmly – dial-in the final resistance value needed for your system by turning the screw on the
variable resistor on the side of the unit next to the Dip Switches. Turn the screw until the resistance value matches the
resistance value of the key.
9. Connect the bypass module using the diagram on the next page. Be sure to tape up any connections
DO NOT
leave
any exposed wires.
10. When connecting the Anti-Theft Bypass Module to your Remote Starter, you will need to activate this Bypass Module
by connecting it in different ways depending on the Remote Starter you have. Attach the
WHITE/GREEN and
GRAY/BLACK (-) Security Bypass Output
wires from the 8-Pin Harness to: if the unit you are using has a
4-Relay
Pack
, tap this
WHITE/GREEN and GRAY/BLACK
wires into the Thin
WHITE
wire in the middle of the
3-Pin Plug
, if
the Remote Start does not have a 4-Relay Pack and the Relays are On-Board, connect the
WHITE/GREEN and
GRAY/BLACK
wires to the
WHITE, YELLOW or YELLOW BLACK (-)Negative Ignition Output or (-) Security
Bypass Output
wire from the Main Harness on these Remote Starters. On the
DELUXE 200 or DELUXE 500 Models,
connect this
GREEN/WHITE and GRAY/BLACK
wires to
the BLUE/BLACK Ignition 3 Control Output wire, the H4/9
wire or H7/1 wire.
