1/31/02
5
Module using the diagram below.
6.
When connecting the Anti-Theft Bypass Module to your Remote Starter, you will need to activate this Bypass Module
by connecting it in different ways depending on the Remote Starter you have. Attach the
WHITE/GREEN (-)Security
Bypass Output
wire from the 8-Pin Harness to: if the unit you are using has a
4-Relay Pack
, tap this
WHITE/GREEN
wire into the Thin
WHITE
wire in the middle of the
3-Pin Plug
, if the Remote Start does not have a 4-Relay Pack and
the Relays are On-Board, connect the
WHITE/GREEN
wire to the
WHITE, YELLOW or YELLOW BLACK (-)Negative
Ignition Output or (-) Security Bypass Output
wire from the Main Harness on these Remote Starters. On the
DELUXE 200, DELUXE 200B or DELUXE 500 Models,
connect this
GREEN/WHITE
wire to
the BLUE/BLACK
Ignition 3 Control Output wire, the H4/9 wire or H7/1 wire.
PASSLOCK I
:
1. Remove the Lower Steering Column cover on the Steering Column.
2. Locate the
(3)Three Small 20 Gauge
wires
(YELLOW, BLACK and WHITE wires in a GRAY or BLACK Plug)
coming out of the Ignition Key Cylinder on the Bottom right hand side of the Steering Column.
3. Cut the
YELLOW
wire in half and strip back both ends. Remove some of the insulation on the
BLACK
wire without
cutting the wire and the
WHITE
wire
is not used!!
.
4. Put the vehicle into reverse then turn the ignition key to the Start position and release it to the run position. The vehicle
