1/31/02
11
Switch. Use the double stick foam tape provided, one layer on the circuit board and then the Transponder Key, and
finally the second double-stick foam tape layer on top of it to hold key securely in place, See Below:
3. The
TRANSPONDER LOOP
Antenna
must be routed through the Steering Column and up towards and then around
the
Ignition Key Cylinder
and needs to be positioned so that there are at least (2)Two turns (the more turns the better
chance the signal will be Received by the Factory Receiver Antenna) around the Ignition Key Cylinder as shown below.
Transponder systems often have a
BLACK PLASTIC RING
around the Ignition Lock Switch. This is the vehicle’s
Transponder Pick-up or Receiver Ring Antenna. It is important that the
at Least (2) Two loops
of the Bypass Module’s
TRANSPONDER LOOP ANTENNA
be mounted on or as close to the Factory Receiver Ring (BLACK PLASTIC RING)
as possible. Slide the tube up towards the ignition switch to tighten up the loops of wire. Tape in place to hold. Plug the
2-Pin Connector of the Transponder Loop Antenna into the Universal Bypass Module.
4. Now start the vehicle with the Remote Starter. If the vehicle starts and runs for at least 30 seconds the Transponder
Bypass Module, the placement of the Key inside the Bypass Module and the Transponder Loop Antenna are installed
correct.
Note: If the vehicle does not start with the Remote Starter or runs for approx 5 seconds and shuts down, try adjusting or
changing the position of the Transponder Key in the Bypass Module or adjusting the position of the (2)Two Loop Antenna
wire around the Transponder Pick-up/Receiver Antenna as mentioned above.
5. When connecting the Anti-Theft Bypass Module to your Remote Starter, you will need to activate this Bypass Module by
connecting it in different ways depending on the Remote Starter you have. Attach the
WHITE/GREEN (-)Security Bypass
Output
wire from the 8-Pin Harness to: if the unit you are using has a
4-Relay Pack
, tap this
WHITE/GREEN
wire into the
Thin
WHITE
wire in the middle of the
3-Pin Plug
, if the Remote Start does not have a 4-Relay Pack and the Relays are
On-Board, connect the
WHITE/GREEN
wire to the
WHITE, YELLOW or YELLOW BLACK (-)Negative Ignition Output
