Bull Novascale R410E1, User Manual

Page: 192 / 324

User Guide
192
www.bull.com
10. Lift the fan from the bracket. See letter “B” in the figure below.
Figure 133: Removing Fan from Fan Bracket
11. Install the replacement fan onto the bracket, using the two screws you removed
in step 9.
12. Set the fan assembly into the system. Insert the rear edge first and push the
assembly slightly rearward to clear the hard disk drive brackets. Use caution to
make sure you do not pinch any cables.
13. Route the cable from the fan at the right around the right side of the assembly
and under the clip at the front of the fan bracket.
14. Connect the fans to the server board. See letters “A” and “B” in the figure
below.
Figure 134: Connecting System Blower Fans
15. Install the processor air duct. Refer to “Installing the Processor Air Duct” on
page 165 .
16. Replace the server cover. Refer to “Installing the Server Cover” on page 163 .
17. Plug all peripheral devices and the AC power cable into the server.
B
A