User Guide
162
www.bull.com
Removing or Installing the Server Cover
The server must be operated with the server cover in place to ensure proper cooling.
Remove the cover to add or replace components inside of the server.
None of the internal components are hot-swappable.
Note: Use a nonskid surface or a stop behind the server to
prevent it from sliding on your work surface.
Removing the Server Cover
1.
Make sure the power switches for the computer, video monitor and any
peripheral devices are turned OFF and unplug the power cord (see
“General
Safety Information” on page 134
).
2.
Disconnect the monitor and peripheral devices (printers, for instance) from the
system.
3.
Remove the two screws at the front of the chassis. See letter “A” in Figure 104.
4.
Loosen the screw at the rear of the chassis. See letter “B” in Figure 104.
5.
Push rearward on the blue grip point at the front of the server. Slide the cover
back until it stops and then lift the cover upward to remove it. See letter “C” in
the figure below.
Figure 104: Removing the Server Cover
Summary of Contents for Novascale R410E1
