Bull Escala PL 1650R-L+, Hardware Information

Page: 80 / 90

Install the front cover on the model 112/85, ESCALA PL 250T/R, PL
250T/R+ or PL 450T/R-L+, ESCALA PL 450T/R, PL 450T/R+ or PL
850T/R-L+, or the 05/95 expansion unit
The following procedures describe how to install the front cover for the rack-mounted and stand-alone model
112/85, ESCALA PL 250T/R, PL 250T/R+ or PL 450T/R-L+, ESCALA PL 450T/R, PL 450T/R+ or PL
850T/R-L+, or the 05/95 expansion unit.
Parent topic: Remove the front cover from the model 112/85, ESCALA PL 250T/R, PL 250T/R+ or PL
450T/R-L+, ESCALA PL 450T/R, PL 450T/R+ or PL 850T/R-L+, or the 05/95 expansion unit
Verify the installed part
This topic describes how to verify a newly installed or replaced part on your system, logical partition, or
expansion unit. Verify an installed feature or replaced part by selecting the appropriate procedure for the
operating system or for the console as follows.
Verify an installed feature or replaced part on an AIX system or logical partition •
Verify the installed part on a Linux system or logical partition (run AIX diagnostics) •
Verify the presence of an installed part using Hardware Management Console (HMC)
Use these instructions to verify an installed part using the Hardware Management Console (HMC). If
you have reference codes, symptoms, or location codes that you used during the service action,
locate the records to use during this procedure.
•
Verify the presence of an installed part using the Advanced System Management Interface
(ASMI)
Use these instructions to verify a newly installed part or replaced part using the Advanced System
Management Interface (ASMI).
•
Parent topic: Related procedures
Verify an installed feature or replaced part on an AIX system or logical
partition
To verify the operation of a newly installed feature or replacement part, select the appropriate procedure:
Verify the installed feature using AIX •
Verifying the replaced part using AIX •
Verify the installed feature using AIX:
Log in as root user. 1.
At the command line, type
diag
and press Enter. 2.
Select Advanced Diagnostics Routines . Press Enter. 3.
From the Diagnostic Mode Selection menu, select System Verification . Press Enter. 4.
When the Advanced Diagnostic Selection menu appears, do one of the following:
To test a single resource, select the resource that you just installed from the list of resources
and press Enter. ♦
To test all the resources available to the operating system, select All Resources and press
Enter.
♦
5.
Select Commit , and wait until the diagnostic programs run to completion, responding to any prompts
that appear.
6.
Did the diagnostics run to completion and display the message
No trouble was found
?
No: If a service request number (SRN) or other reference code is displayed, suspect a loose
adapter or cable connection. You can learn more about these codes in Reference codes .
♦
7.
Control panel
74 Install the front cover on the model 112/85, ESCALA PL 250T/R, PL 250T/R+ or PL 450T/R-L+, ESCALA PL 450T/R, PL 450T/R+ or PL 850T/R-L+, or the 05/95 expansion unit