Simultaneously release the safety latches, located near the middle of each side of the system, and
push the system unit into the rack. Both rack latches should lock into position.
Note:
Ensure that the cables at the rear of the system unit do not catch or bind as you push the unit
back into the rack.
2.
Replace and tighten the two screws A that secure the system unit to the rack as shown in the
following figure.
Figure 1. Replace the thumbscrews
3.
Connect the cables and cords.
4.
Replace the cable management arm.
5.
Close the front rack door.
6.
Parent topic:
Remove the front cover from the model ESCALA PL 250R-L, PL
250R-L+ or PL 450R-VL+ or 7/10
To remove the front cover, follow these steps:
If necessary, open the front rack door.
1.
Push both cover-release latches A down to release the cover as shown in the following figure.
2.
Pivot the cover from the bottom and swing the top of the cover out.
3.
Pull the bottom of the cover up and then away from the system unit. This releases the two tabs
located on the bottom of the cover.
4.
Put the cover in a safe place.
5.
Install the front cover on the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+
•
Control panel
Remove the front cover from the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ or 7/10
59
Summary of Contents for Escala PL 1650R-L+
