Bull Escala PL 1650R-L+, Hardware Information

Page: 72 / 90

Connect all devices installed in a rack cabinet to power devices installed in the same rack cabinet. Do
not plug a power cord from a device installed in one rack cabinet into a power device installed in a
different rack cabinet. •
An electrical outlet that is not correctly wired could place hazardous voltage on the metal parts of the
system or the devices that attach to the system. It is the responsibility of the customer to ensure that
the outlet is correctly wired and grounded to prevent an electrical shock. •
CAUTION
Do not install a unit in a rack where the internal rack ambient temperatures will exceed the
manufacturer's recommended ambient temperature for all your rack-mounted devices. •
Do not install a unit in a rack where the air flow is compromised. Ensure that air flow is not blocked or
reduced on any side, front, or back of a unit used for air flow through the unit. •
Consideration should be given to the connection of the equipment to the supply circuit so that
overloading of the circuits does not compromise the supply wiring or overcurrent protection. To
provide the correct power connection to a rack, refer to the rating labels located on the equipment in
the rack to determine the total power requirement of the supply circuit. •
(For sliding drawers.) Do not pull out or install any drawer or feature if the rack stabilizer brackets are
not attached to the rack. Do not pull out more than one drawer at a time. The rack might become
unstable if you pull out more than one drawer at a time.
•
(For fixed drawers.) This drawer is a fixed drawer and must not be moved for servicing unless
specified by the manufacturer. Attempting to move the drawer partially or completely out of the rack
might cause the rack to become unstable or cause the drawer to fall out of the rack.
•
(R001)
To place the rack-mounted system or expansion unit into the service position, follow these steps:
If necessary, open the front rack door. 1.
Remove the two thumbscrews A that secure the system or expansion unit B to the rack as shown in
the following figure. 2.
Release the rack latches A on both the left and right sides as shown in the following figure. 3.
Control panel
66 Place the rack-mounted system or expansion unit in the serviceposition