Consideration should be given to the connection of the equipment to the supply circuit so that
overloading of the circuits does not compromise the supply wiring or overcurrent protection. To
provide the correct power connection to a rack, refer to the rating labels located on the equipment in
the rack to determine the total power requirement of the supply circuit.
•
(For sliding drawers.)
Do not pull out or install any drawer or feature if the rack stabilizer brackets are
not attached to the rack. Do not pull out more than one drawer at a time. The rack might become
unstable if you pull out more than one drawer at a time.
•
(For fixed drawers.)
This drawer is a fixed drawer and must not be moved for servicing unless
specified by the manufacturer. Attempting to move the drawer partially or completely out of the rack
might cause the rack to become unstable or cause the drawer to fall out of the rack.
•
(R001)
To place the rack-mounted system unit into the service position, follow these steps:
If necessary, open the front rack door.
1.
Remove the two thumbscrews A that secure the system unit to the rack as shown in the following
figure.
2.
Release the rack latches B on both the left and right sides as shown in the previous figure.
3.
Review the following note, and then slowly pull the system unit out from the rack until the rails are fully
extended and locked.
Note:
If the procedure you are performing requires you to unplug cables from the back of the
system unit, do so before you pull the unit out from the rack.
♦
Ensure that the cables at the rear of the system unit do not catch or bind as you pull the unit
out from the rack.
♦
Ensure the rails are fully extended. When the rails are fully extended, the rail safety latches
lock into place. This action prevents the system unit from being pulled out too far.
♦
4.
Parent topic:
Remove the front cover from the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+
Place the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ or
7/10 in the operating position
Learn how to place the unit into the operating position.
Tip:
Some of the figures in these procedures might not look exactly like the system unit that you have.
However, the steps to perform the task are the same.
Control panel
62
Place the model ESCALA PL 250R-L, PL 250R-L+ or PL 450R-VL+ or 7/10 in the operating position
Summary of Contents for Escala PL 1650R-L+
