WPL-05G300 Series User Manual
102
Chapter 5 Trouble Shooting
If the AirStation is reset, it is disconnected from the
network.
If the Power LED is flashing, use the procedure below to set the pairing.
1. Hold down the PLC button of the AirStation until the Power LED starts blinking (about 2
seconds).
2. Within 2 minutes, hold down the PLC button of the other AirStation until the Power LED
starts blinking (about 2 seconds).
3. Check that the Power LED changes to steady green after about 1 minute.
If the Power LED does not stop blinking, pairing has failed. Try performing the procedure again from
the beginning.
The link speed is slower than 300 Mbps.
By default, the AirStation’s 300 Mbps mode is not enabled. You may enable it with the following
procedure:
1. Open the Settings (chapter 3).
2. In Easy Setup, click [Wireless SSID & Channel (11n 300 Mbps Mode)].
3. Change the value in [300 Mbps Mode] - [Bandwidth] to 40 MHz and click [Apply].
If you still cannot connect at 300 Mbps, check the settings of your wireless client devices.
