Page 9
INSTALLATION PROCEDURE
(Use a chimney connector or a Listed Direct or Positive Connect) (See Page 9.)
POSITIONING THE HEATER
When positioning heater, following conditions MUST be
met! (See Figure 2).
1. The front of damper opening must be positioned
BEHIND back edge of lintel to ensure proper draft.
(See Figure 2).
2. Center heater in the fireplace opening.
MOUNTING THE TRIM PANELS
After unit is positioned, mark mounting position of trim
panels as follows:
1. Place side trim panels in place, flat against face of
fireplace. Mark front edge of trim panel with pencil
to make vertical reference line. (See Figure 3).
2. Place long trim panel on top of unit. The panel
should be flat against outside face of fireplace and
standing vertically. Mark the lower edge of trim
panel with a pencil to make a reference line for
mounting.
3. Slide unit out of fireplace far enough to work
behind trim panel reference lines.
4. Mount side trim panels. (See Figure 3).
a. Position trim panel on reference line.
FIGURE 3 MOUNTING TRIM PANELS
FIGURE 2 POSITIONING
b. Drill mounting holes in center of trim panel mounting brackets to allow for adjustment in
and out if necessary.
c. Mount trim panel using self-tapping screws provided.
5. Place top panel back on reference mark. Top trim panel mounting bracket is supplied with unit. Position
bracket so it overlaps rear lip of top trim panel. Drill mounting holes in top of stove using holes in bracket as
guide. Tighten screws.
6. Follow installation procedures in listed direct connect or positive connect kit you are using and install heater
connect kit in fireplace. If not using one of the installation methods shown on
(Page 9), continue.
7. Slide unit back into the fireplace. Ensure trim panels are properly positioned and lie flat against front of fire-
place. If one or more panels is out of position, slide unit out and reset by loosening mounting screws and re-
positioning in slot. Reinstall top trim panel by sliding rear lip of top trim panel underneath front lip of mount-
ing bracket already secured to top of unit.
8. NOTE: Mount the top trim panel so that it sits in front of the top of the side trim panels.
Summary of Contents for MODEL 20
Page 2: ......
