Page 55
F. DO NOT build a fire directly inside the ZC20. It is designed solely for housing the Model 20.
G. WARNING: Do not install in sleeping room.
H. CAUTION: The structural integrity of mobile home floor, wall, and ceiling/roof must be maintained.
I.
Do not connect this unit to a chimney serving another appliance.
FRAMING CONSTRUCTION AND INSTALLATION
Except as noted, ZC20 can be installed almost anywhere you desire. There are, however, a few clearance and
framing restrictions that must be followed. See Figure 5 and 6 to make sure that these clearance restrictions are
met. It is much wiser to place your ZC20 correctly at start of the installation than to be forced to relocate it after
much of work is done.
You must ensure that the floor is of adequate strength to accept load of this unit. If inadequate, floor will require
additional support, such as bracing. NOTE:
A wooden base constructed of plywood or 2”x4” boards is required in
order to get proper clearance above extended hearth (millboard, rock, stone, etc.)
Where cabinet is to be placed, a 4 1/4” diameter hole with a 2 1/8” radius from center line must be cut through
floor. Outside air duct kit #PP 70075-01 is be installed. (See Figure 9).
1. Thoroughly clean area where unit will be placed. Remove any carpeting/padding from area where ZC20 will
be installed.
2. Layout location on floor for ZC cabinet. NOTE:
Maintain 3/4” clearance between rear of cabinet and
combustible material.
3. Layout for hearth extension preparation and removal of carpet and padding. Where cabinet is to be placed, a 4
1/4” diameter hole with a 2 1/8” radius from center line must be cut through floor. Outside air duct kit # PP
70075-01 is to be installed. (See Figure 9).
4.
Next, a sheet metal safety shield is placed 1 1/2” under front of cabinet. It must extend out under floor
protector. Drop a plumb line, locate and mark point on ceiling directly over center of ZC20 chimney adapter.
After locating center of hole, install fire stop spacer, per chimney manufacturers instructions.
FIGURE 8
25”
INTERIOR LOCATION
CORNER
LOCATION
Summary of Contents for MODEL 20
Page 2: ......
