BTM Scandinavia AB
●
Franska vägen 32
●
S-393 56 KALMAR
●
Tel: +46 480 868 75
3.0 Tooling
3.1 Tool check
1. Constantly check that the Tog-L-Loc® tools are not damaged.
Check the condition of the punch, look for signs of damage. If it is damaged,
replace the damaged part with a new one, follow the instructions that are
provided later in this section.
Check the condition of the die. Make sure the blades are properly closed and
is not kept open because of dirt or other debris. If so, remove and clean the
die as instructed later on in this section.
Check the condition of the elastomer. If signs of wear, dehydration or visible
cracks, elastomer needs to be replaced. See instructions later in this section.
Check the dimension of the joint, Button Cap Thickness and Button Diameter.
If not in accordance mesuring what is recommended, contact BTM
Scandinavia for additional support.
CT
Tn
– Hals T
f
– Låsning
CT
– Knapptjocklek, restmått
h
– Knapphöjd
BD - Knappdiameter
Summary of Contents for ULBG 452-18
Page 28: ...S 7 ...