OL-B500-05
Assembly filler profile on L1 and L2
1
SW10
3x
M6 x 40
› Take the screens out of the mainhousings.
› Fit 1 screw on the side of the door profile (6.3x50) + 1 x M6 x 40.
› Turn them to 10mm from the end.
› Slide the mainhousings over the door pole (1).
› Fully tighten the screw 6.3x50.
› Do the same with the bottom screws (2).
› Fasten the coverplate on the door profile with 2 screws (4.2x19) (3).
2
4.2 x 19
3
6.3 x 50
2
1
Assembly filler profile on W1
SIDE WITH DOOR PROFILE
W1
› With beam L1 and L2 (and if a door profile was provided on the W1 side) a filler p cover is supplied.
› Place these as shown on the drawings below.
› Fix with self-tapping screws (1) close off the profile with the cover.
› Fix the cover with three screws (2).
Self-tapping screw 4.2x13
No hole needs to be drilled
1
L1/L2
2
3/8”
