Bruno Curb-Sider VSL-6000, Operator'S Manual

Page: 10 / 24

10
©BRUNO
VSL-6000/6900UK Operator’s 04/16/201
Stop before stitch
line gets to belt
guide.
belt guide.
STEP 5.2
• Locate the control pendant.
• Be sure the pendant is not tangled in the lift
mechanism.
• Depress and hold the UP switch on the control
pendant to raise the C-arm/pickup claw high
enough to avoid catching on something as the
lift swings out of the vehicle.
• Release the button.
• Depress the OUT switch on the control pendant
to swing the lift arm out of the vehicle.
NOTE:
Hold the C-arm/pick-up claw as the lift is
powered out to prevent the pick-up device
from swinging freely and contacting the
side of the vehicle.
• Release the switch when the lift arm is over the
mobility device.
NOTE:
Releasing a pendant switch stops lift
operation.
STEP 5.3
• With the lift positioned over the mobility de-
vice, depress and hold the DOWN switch on the
control pendant.
• Guide the C-arm/pickup claw to a position slight-
ly below the docking device (installed on the
mobility device by your dealer).
• Hook the C-arm/pickup claw onto the docking
device as shown at the front of this manual.
• Depress and hold the UP switch on the control
pendant to lift the mobility device. N
NOTE: It may be necessary to raise the
scooter until the C-arm/pickup claw is
approximately 1” (25 mm) below the belt
guide.
• Release the switch before the white stitching on
the belt reaches the belt guide.