Bruno Curb-Sider VSL-6000, Operator'S Manual

Page: 12 / 24

12
©BRUNO
VSL-6000/6900UK Operator’s 04/16/201
6.0 UNLOADING A MOBILITY DEVICE
NOTE:
Releasing a pendant switch stops lift
operation.
To transfer the mobility device
from the vehicle onto a
sidewalk, park the vehicle so
that its wheels are within
approximately two 2" (5 cm)
of the curb.
During loading and unloading,
always guide the mobility
device by appying gentle pres-
sure with your hand. This will
keep the mobility device from
rotating while suspended, and
possibly damaging the vehicle.
STEP 6.2
• Depress and hold the UP button on the control
pendant to lift the mobility device from the
vehicle floor.
• When the scooter is at a height where it will
not catch on anything, release the UP button to
stop lift operation.
• Depress and hold the OUT button on the control
pendant to swing the scooter out of the vehicle.
NOTE:
Be sure to guide the mobility device with
your hand.
• When scooter is suspended over the desired location,
release the OUT button to stop lift operation.
• Depress and hold the DOWN button on the
control pendant to lower the mobility device to
the ground.
• Release the DOWN button once the mobility
device reaches the ground, and after a sufficient
amount of slack exists in the belt to allow you
to unhook the C-arm from the docking device.
STEP 6.1
• Park the vehicle in a location allowing ample
room to unload the mobility device.
• Open the vehicle door.
• Check for sufficient space behind your vehicle.
Four (4) feet (1.2 m) of clear space behind the
vehicle is usually adequate.
• Be sure there are no obstacles that could inter-
fere with the movement of the mobility device
as the lift swings it into the vehicle.
• Locate the control pendant.
• Be sure the pendant is not tangled in the lift
mechanism.
• Position yourself out of the exit path of the lift
as it swings out of the vehicle.