Installation Instructions 125 MAX DD2 evo
Page 10/70
Edition 09/2016
4.
Installation of the Bowden cable for carburetor control
See Fig. 6.
Æ
Carefully remove the carburetor cover and the rubber ring (pos. 7, 8).
¢
Attention: Reset spring (pos. 6) of carb piston presses against carburetor cover and might
eject carburetor cover at removal.
Æ
Remove nipple screw (pos. 5) with A/F 10 wrench from carburetor piston (pos. 2).
Æ
Engage nipple of Bowden wire (pos. 9) in nipple screw (pos. 5).
Æ
Fit nipple screw in carburetor piston and hand-tighten with A/F 10 wrench.
Æ
Insert carburetor piston (pos. 2) into carb body with recess of piston towards intake
silencer.
Æ
Pass Bowden wire through compression spring (pos. 6) and through cover with
rubber ring (pos. 7, 8) of carburetor.
Æ
Fit carb cover (pos. 7) on carburetor.
Æ
Pass Bowden wire through Bowden conduit and through adjustment screw on
chassis (throttle pedal).
Æ
Connect Bowden cable to throttle pedal.
Fig. 6
¿
Note:
Shorten Bowden cable as required.
