Brouwer Kesmac 4000 R Series, Operator'S Manual

Page: 96 / 161

ELECTRICAL SYSTEM
Proximity Sensors
IMPORTANT
To prevent loss of signal from a Sensor it is imperative that a regular check is carried out to
ensure that no dirt/debris is allowed to build up on the face of the sensor or the sensor target.
If a Proximity Sensor, or the target component, is replaced it must be adjusted, where applicable,
to allow a gap between the face of the sensor and the target as indicated below.
1. Cut-Off - Sensor to Target
1/4 in. to 3/8 in. 2. Conveyor ‘DOWN’ - Sensor to Target 1/8 in. to 1/4 in.
3. Slab End Sensor. See P3-18 for calibration. 4. Roll Flap (Tooth Count) Sensor to Target
1/8 in.max
5. Index Conv’.‘CLEATS’ position Sensor to Target
. 6. Mast ‘Height’ Sensor. No adjustment.
1/8 in. to 1/4in
5-08