Brother KE-430F Series, Service Manual, Page: 51 / 184

6. X AND Y PARALLEL MOVEMENT OF SEWING PATTERNS
41 KE-430F, BE-438F
6. X AND Y PARALLEL MOVEMENT OF SEWING
PATTERNS
The work clamp/button clamp can be moved to any desired position so that sewing patterns which have already been
programmed can be moved in parallel directions forward, back or to the left or right.
Use this when you would like to correct the sewing position with respect to the work clamp/button clamp.
1 Press the or key to select the program number.
* If a cycle program has been selected, the following
operation cannot be carried out. Select a program
from 1 to 999.
2
While holding down the TEST key, press the key to
switch to parallel movement mode.
・
The amount of parallel movement in the horizontal
direction which has currently been set will be
displayed in the menu display in mm units.
* The sewing machine will not switch to parallel
movement mode if memory switch No. 465 is set to
“3”.
Set it to “1” or “2”.
3 Depress the foot switch to the 2nd step.
・
Home position detection will be carried out.
・
The pattern number will change to illuminated.
4
Each time the or key is pressed, the work
clamp/button clamp will move by 0.05 mm.
・
In X-scale parallel movement mode, the work
clamp/button clamp will move to the left when the
key is pressed, and to the right when the key is
pressed.
・
The range of movement is a maximum of -9.95 mm to
+9.95 mm. However, the sewing pattern cannot be
moved outside the sewing area.
5 Confirm the movement amount. Press the ENTER key.
・
The amount of parallel movement in the horizontal
direction will be confirmed, and the menu display will
change to illuminated.
2776B
For example, program
No. 1
2778B
2414B
For example, set to 0.05.
2nd step
4441Q
2777B 2648B
(Continued on next page.)