Brother KE-430F Series, Service Manual, Page: 30 / 184

4. FUNCTION SETTINGS
20 KE-430F, BE-438F
No. Setting range Initial value Setting units Setting details
582 ON/OFF ON 1
Upper thread tension tightening at the sewing start
ON: Enabled
OFF: Disabled
583
-150
−
150
(degrees)
0 5
Upper thread tension change (tightening) angle offset at the
sewing start
584
-110
−
40
(degrees)
0 5 Upper thread tension release angle offset at the sewing end
585 0
−
500 470 1 Upper thread tension value (tightening) at the sewing start
587
0
−
300
0 1 Upper thread tension value (release) at the sewing start
588
0
−
50
(ms)
35 1 Thread trimmer solenoid ON timing
589
0
−
50
(ms)
20 1 Thread trimmer solenoid ON time
590
5
−
10
5 1 Thread trimmer solenoid holding force
430F: 270
591
0
−
300
(degrees) 438F: 260
5 Specified final speed output angle offset
592
200
−
700
(sti/min)
600 100 Last stitch sewing speed for upper shaft motor
593
0
−
15
(ms)
8 1
Speed change delay until thread nipper operation is complete
* If the thread nipper device is not to operate, set to “0”.
594
-160
−
20
(degrees)
0 5 Needle up stop signal output angle offset
Error processing settings (600
−
699)
No. Setting range
Initial
value
Setting units Setting details
650
*1
*2 0
−
2 0 1
Error release method when operation has stopped
0: Press the RESET key on the operation panel.
1: Press the STOP switch (available by special order).
2: Press the external input switch (EXIN2).
651
*2
ON/OFF OFF -
Needle stop position when sewing is interrupted by the STOP
switch (available by special order)
ON: Needle stops in the up position.
OFF: Needle stops in the down position.
652
*2
ON/OFF OFF -
Thread trimming operation when sewing is paused
ON: Thread trimming is not carried out when the pause is
canceled.
OFF: Thread trimming is carried out when the pause is
canceled.
654
*2
ON/OFF OFF -
Use of STOP switch (available by special order)
ON: Used
OFF: Not used
655 ON/OFF OFF -
Disables needle up stop position monitoring.
ON: Disabled
OFF: Enabled (If the needle up stop position is incorrect, “UP”
will be displayed.)
657
OFF, 2
−
30
(seconds)
OFF 2
Time from error occurring to buzzer stopping
OFF: Buzzer does not stop.
2 – 30: Buzzer stops after the specified time.
*1: This is not initialized during initialization mode.
*2: These functions can be used if the main PCB version is 1.5.00 or later.