Brother KE-430F Series, Service Manual, Page: 36 / 184

4. FUNCTION SETTINGS
26 KE-430F, BE-438F
Item No. Item name Input status Check items and checking methods
[ 5] [orP] [ on] / [ oFF]
Work clamp motor home position sensor position
Remove the side cover and raise the work clamp/button clamp
manually.
* ON when raised, OFF when lowered.
[ 6] [EnP]
[-999]
−
[ 999]
Work clamp motor encoder counter value
Remove the side cover and raise the work clamp/button clamp
manually.
* Back = down, and forward = up.
* When the power is turned on, the position will be “0”.
[ 7] [dEG]
[ 000]
−
[ 359]
Upper shaft 360 rotation segment signal
Turn the pulley by hand.
* The forward direction (the direction of the arrow) = up.
[ 8] [ UP] [ on] / [ oFF]
Needle up signal
Turn the pulley by hand.
* ON in the needle up region, OFF in any other region.
[ 9] [voL] [ ***] Shows the input voltage.
[ 10] [PnL] [*] / [ oFF]
Operation panel key input check
The key name will be displayed while a key is pressed.
* ON display Key name
[rESt] RESET key
[tESt] TEST key
[tHrE] THREAD/CLAMP key
[ tEn] TENSION key
[SELE] SELECT key
[UP-M]
key
[dn-M]
key
[UP-S] SECTION + key
[dn-S] SECTION - key
[UP-t] TENSION + key
[dn-t] TENSION - key
[ F1] Function key F1
[ F2] Function key F2
[ F3] Function key F3
[ F4] Function key F4
[ Ent] ENTER key
[ 11] [FtA]
[ 0]
−
[ 255]
Foot switch analog value
Depress the foot switch.
* When depressed forward, the value increases.
* Should normally display somewhere around 102 when at the
neutral position.
[ 12] [FtS]
[bAck] / [oFF] /
[CLnp] / [Strt]
Foot switch signal
bAck: Depressed backward
oFF
：
Neutral
CLnP
：
1st step (Work clamp signal)
Strt ： 2nd step (Start signal)
[ 13] [CL1] [ on] / [ oFF]
Work clamp switch 1st step for 2-step foot switch
Depress the work clamp switch to the 1st step.
[ 14] [CL2] [ on] / [ oFF]
Work clamp switch 2nd step for 2-step foot switch
Depress the work clamp switch to the 2nd step.
[ 15] [Stt] [ on] / [ oFF]
Start switch for 2-step foot switch
Depress the start switch.