Brother Innov-is NV6000D, Operation Manual

Page: 340 / 376

CARE AND MAINTENANCE
326
CARE AND MAINTENANCE
Cleaning the LCD Screen
If the screen is dirty, gently wipe it with the
included LCD cleaning cloth or a soft, dry cloth.
Do not use organic solvents or detergents.
Cleaning the Machine Casing
If the surface of the machine is dirty, lightly soak a
cloth in a neutral detergent, squeeze it out firmly,
and then wipe the surface. Then wipe again with a
dry cloth.
Cleaning the Race
If dust or bits of dirt collect in the race or bobbin
case, the machine will not run well, and the
bobbin thread detection function may not operate.
Keep the machine clean for best results.
Press
→ → →
→
in this order to display a
video example of cleaning the race (see page 34).
Follow the steps explained below to complete the
operation.
a
Press the “Needle Position” button to raise
the needle.
b
Turn the main power to OFF.
c
Remove the needle and the presser foot
holder (see pages 55 through 56).
d
Remove the flat bed attachment or the
embroidery unit if either is attached.
e
Grasp both sides of the needle plate cover,
and then slide it toward you.
a
Needle plate cover
→
The needle plate cover is removed.
f
Grasp the bobbin case, and then pull it out.
a
Bobbin case
CAUTION
• Be sure to unplug the machine before cleaning it. Otherwise, electric shock or injury may result.
Note
• Do not wipe the LCD screen with a damp
cloth.
Memo
• Occasionally, condensation may form on the
LCD screen or it may become fogged up;
however, this is not a malfunction. After a
while, the cloudiness will disappear.