Brother Innov-is NV6000D, Operation Manual

Page: 36 / 376

LCD SCREEN
22
Using the Machine Setting Mode Key
Press to change the default machine settings (needle stop position, embroidery speed, opening
display, etc.). To display the different settings screens, press for “Sewing settings”, for
“General settings” or for “Embroidery settings”.
Sewing settings
a
Select whether to use the sewing speed controller to determine the zigzag width (see page 104).
b
Make adjustments to character or decorative stitch patterns (see page 153).
c
Adjust the presser foot height. (Select the height of the presser foot when the presser foot is raised.)
d
Adjust the presser foot pressure. (The higher the number, the greater the pressure will be. Set the pressure at “3” for
normal sewing.)
e
Select whether “1-01 Straight stitch (Left)” or “1-03 Straight stitch (Middle)” is the utility stitch that is automatically
selected when the machine is turned on.
f
Change the height of the presser foot when sewing is stopped when the pivot setting is selected (see page 72).
Adjust the presser foot to one of the three heights (3.2 mm, 5.0 mm and 7.5 mm).
g
Change the height of the presser foot when the machine is set to free motion sewing mode (see page 105).
h
When set to “ON”, the thickness of the fabric is automatically detected by an internal sensor while sewing. This
enables the fabric to be fed smoothly (see pages 64 and 73).
Memo
• Press or to display a different settings screen.
a
b
c
d
e
f
g
h