Brother HL-7050 Series, Service Manual

Page: 127 / 326

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
4-10
(6) Place the paper tray unit the correct way up and slide the side guide R ASSY and the side
guide L to the center. Remove the side guide R ASSY and the side guide L from the
paper tray.
NOTE:
When replacing the side guide R ASSY, be sure to replace the size detection cam also. Refer
to (16) in this section.
Fig. 4-7
(7) Remove the four bind B M4x10 Taptite screws from the EX rear tray guides at the right
and left hand sides of the paper tray.
While pushing up the boss of the EX rear tray guide on the back of the paper tray, slide
the EX rear tray guide and EX rear tray together backwards in the tray to remove them.
Since the plate unit also is released at the same time, unhook the hooks at the right and
left hand sides by pulling the paper tray frame outwards to remove the plate unit from the
paper tray unit.
Fig. 4-8
Side guide R ASSY
Side guide L
Paper tray
Plate unit
EX rear tray
Taptite, bind B M4x10
EX rear tray guide
Boss
Boss
Taptite, bind B M4x10
EX rear tray guide
Paper tray
SGR extension spring