6. Maintenance
GT-3 Series
113
6-1-3. Replacing Flushing Plate Sponge and Flushing Plate Felt
(1)
After replacing the Wiper Cleaner, replace the Flushing Plate Sponge and Flushing Plate Felt.
Remove
the Flushing Plate from the printer by lifting up the right side slightly and pull up to the right direction.
(2) Remove the used Flushing Plate Sponge and Flushing Plate Felt from the Flushing Plate and remove the
waste ink inside. Put the new Flushing Plate Sponge (top) and Flushing Plate Felt (bottom) into the Flushing
Plate and mount the Flushing Plate as it is to the printer.
<Note>
Keep clean the top edge of the Flushing Plate; if it is covered with dust and clogged ink, the Print Heads
may touch the surface and mis-firing may occur.
Dispose the used Waste Ink in accordance with your local regulations. Or make contact to your dealer.
0067Y
6-1-4. Replacing the Fan Filter
(1) Put the gloves on your both hands, and put your left hand from the space before the Timing Belt to reach the
Filter Cover.
(2) Lift up the Lock (1) of the Filter Cover with your left hand and move the Filter Cover to the opposite direction of
the Fan and pull out the Filter Cover by removing the Guide Holes from the projections.
0068Y
<Note>
Pay attention not to hit the Filter Cover to the Timing Belt.
(1)
Felt
Sponge
Flushing Plate
