GT-3 Series
7. Troubleshooting
154
7-2-9. Adjusting the CR Speed
Execute this menu after you clean the Carriage Shaft, or you are asked from the technical support. See "6-1-6.
Cleaning the inside of the printer and restart".
(1) Press either one of the Up / Down / Back / OK Button to enter the Menu.
(2) Select [ Printer Setting ] > [ CR Speed Adjustment ] with the Up / Down Button and press the OK Button. The
following message will be indicated.
17e0042Y
(3) Wait until the Carriage stops moving and bells.
7-2-10. Adjusting the Flushing Interval
Flushing is very important to keep the print quality. The initial setting is decided on the assumption that the printer
works under the environment of 45 % humidity. Use a humidifier to avoid the Print Heads from clogging with dried
ink as well as increase the frequency of Flushing (to shorten the interval of Flushing) in printing. You can lower
the frequency (to lengthen the interval of Flushing) in more humid environment. Confirm the print quality before
production.
(1) Press either one of the Up / Down / Back / OK Button to enter the menu.
(2) Select [ Printer Setting ] > [ Flushing Interval ] with the Up / Down Button and press the OK Button. The
following message will be indicated.
10e0035Y
(3) The initial setting is [ normal 40 lines ]. Select [ every 20 lines ] in dry environment and [ every 52 lines ]
in humid environment
with the Up / Down Button. Confirm the print quality before production.
11e0036Y
<Note>
Decrease the Flushing Interval (=increase the number of Flushing) with [ Flushing Interval ] menu when the
print quality is not good while printing. On the other hand, increase the Flushing Volume with [ Flushing
Volume ] menu when the print quality is not good at the beginning of the print.
