Brother DCP-T520W, Online User'S Manual, Page: 337 / 496

Error Message Cause Action
• If you are using the PIN Method of
WPS, make sure you have entered the
correct PIN.
Cover is Open. The scanner cover is not locked in the
closed position. Lift the scanner cover and then close it
again.
Make sure the interface cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
The ink tank cover is not locked in the
closed position. Firmly close the ink tank cover until it
locks into place.
Data Remaining Print data is left in the machine's memory. Press Stop/Exit . The machine will cancel
the job and clear it from the memory. Try
to print again.
Disconnected The other person or other person's fax
machine stopped the call. Try to send or receive again.
If calls are stopped repeatedly and you
are using a VoIP (Voice over IP) system,
try changing the Compatibility to Basic (for
VoIP).
See
Related Information : Telephone Line
Interference/VoIP .
Document Jam The document was not inserted or fed
correctly, or the document scanned from
the ADF was too long. Remove the jammed document, and then
press
Stop/Exit . Set the document in the
ADF correctly.
See
Related Information : Load
Documents in the Automatic Document
Feeder (ADF)
.
See Related Information : Document
Jams .
High Temperature The room temperature is too high. After cooling the room, allow the machine
to cool down to room temperature. Try
again when the machine has cooled
down.
Hub is Unusable. A hub or USB flash drive with hub has
been connected to the USB direct
interface. Hubs, including a USB flash drive with a
built-in hub, are not supported. Unplug the
device from the USB direct interface.
Ink Absorber Full The ink absorber box is full. These
components are periodic maintenance
items that may require replacement after
a period of time to ensure optimum
performance from your Brother machine.
Because these components are periodic
maintenance items, the replacement is
not covered under the warranty. The need
to replace these items and the time period
before replacement is dependent on the
number of purges and flushes required to
clean the ink system. These boxes
acquire amounts of ink during the different
purging and flushing operations. The
number of times a machine purges and
flushes for cleaning varies depending on
different situations. For example,
frequently powering the machine on and
off will cause numerous cleaning cycles
since the machine automatically cleans
upon power up. The use of non-Brother
ink may cause frequent cleanings The ink absorber box must be replaced.
Contact Brother customer service or your
local Brother Authorised Service Centre to
have your machine serviced.
331