Brother BAS-311E, Instruction Manual

Page: 173 / 226

Programmer
172
Chapter 3 Programming with Command Function
Modifying the program of a multiple stitch
When modifying the stitch length or the number of lines for a multiple stitch, the previously created
curve program can be used.
The previously created programs are required for modifying programs of multiple stitch.
Programs of multiple stitch written to floppy disks cannot be modified.
Commands to be used
M 5
Input the number of lines for a multiple stitch ranging from 2
to 99 in .
Ex.) The number of lines for a multiple stitch Input value
5 lines 505
M
Input the stitch length in .
1. Press
R
.
The work clamp moves to the home position.
2. Press
9 9 9
.
The needle point moves. When the needle point is at the start point for a multiple stitch, stop it by
pressing .
3. Input the desired number of lines as
M 5
.
4. Input the desired stitch length as
M
.
5. Press
L
.
Calculation is performed based on the input data. When a buzzer stops, the needle point moves to the end
point for a multiple stitch.