Brother ADDENDUM 884-T07, Operation Manual

Page: 227 / 280

Using the Optional Cap Frame 225
7
—————————————————————————————————————————————————————————————————————————————————————
Using the Optional Cap Frame
By using the optional cap frame, patterns can be embroidered onto caps and hats. The procedures for using
the cap frame are described below.
Cap frame and its accessories
The cap frame driver and the mounting jig are required in order to use the cap frame.
Memo
●
Before installing the cap frame, be sure to
adjust the ring of the cap frame driver and
the height of the L-shaped bracket. (If the
same machine is being used, this
adjustment is only required the first time
that it is used. In addition, this adjustment
is not necessary if the included cap frame
is installed.)
●
After the ring of the cap frame driver and
the height of the L-shaped bracket have
been adjusted, they must be adjusted
again if a different machine is being used.
The height may differ depending on the
machine that is used. For details, contact
your authorized dealer.
Note
●
If the cap embroidery frame is attached,
the embroidery frame indicators, showing
which embroidery frames can be used,
appear as shown below.
Advanced cap frame 2
1 Embroidering area:
60 mm (H) × 130 mm (W)
(2-3/8 inches (H) × 5-1/8
inches (W))
2 The mark indicates the center
of the embroidering area.
3 Snap lock
Cap frame driver and 4 thumb
screws
In order to attach the cap frame to
the carriage, remove the
embroidery frame holder, and then
attach this cap frame driver to the
carriage of the machine.
1 Insert the thumb screws into
these holes and tighten the
screws to secure the movable
section. Use these holes when
storing this cap frame driver.
2 Holding Spring
The cap frame is secured by the
two holding Springs.
Mounting jig
Use when framing a cap in the cap
frame.
1 Holders
The cap frame is secured by the
two holders.
2 Mounting bracket
Tighten thumb screw to secure
to mounting surface.
3 Screws
Adjust the size of the mounting
jig according to the type of cap
being embroidered.
Pad Allen screwdriver (large) Allen screwdriver (medium)
• Use when adjusting the ring of the cap frame driver and the height of the L-shaped bracket. (Refer to
page 229.)