Brother 882-W30, Operation Manuals

Page: 83 / 236

SEWING
Se
w
in
g Ba
sics
81
2
* If “Reinforcement Priority” of the settings screen is set to
“ON” (page 30), reinforcement stitches are sewn instead of
reverse stitches.
Automatic Presser Foot Lowering
Function and Thread Cutting
Function
By setting the machine to automatically raise and
lower the presser foot, sewing operations can be
performed more smoothly.
Sewing Curves
Sew slowly while keeping the seam parallel with
the fabric edge as you guide the fabric around the
curve.
Changing Sewing Direction
Stop the machine. Leave the needle in the fabric,
and press the “Presser Foot Lifter” button to raise
the presser foot. Using the needle as a pivot, turn
the fabric so that you can sew in the new
direction. Press the “Presser Foot Lifter” button to
lower the presser foot and start sewing.
The pivot setting is useful when changing the
sewing direction. When the machine is stopped at
the corner of the fabric, the machine stops with the
needle in the fabric and the presser foot is
automatically raised so the fabric can easily be
rotated (“Pivoting” on page 89).
+
Machine starts
sewing and then
sews reinforcement
stitches while
holding the “Reverse
Stitch” button. Machine starts
sewing at the
beginning, then
completes the stitch
pattern and sews
reinforcement
stitches at the end of
sewing.
+
Machine sews
reinforcement
stitches at the
beginning and sews
reinforcement
stitches when the
“Reverse Stitch”
button is pressed. Machine sews
reinforcement
stitches at the
beginning, then
completes the stitch
pattern and sews
reinforcement
stitches at the end of
sewing.
No. Key Name Explanation
a Auto Down When “Auto Down” in the machine
settings screen is set to “ON”,
pressing the “Start/Stop” button or
depressing the foot controller
automatically lowers the presser foot
(if it is raised) before starting to sew.
“Reverse Stitch”
button
“Reinforcement
Stitch” button
a
b
b Press to Trim When “Press to Trim” in the machine
settings screen is set to “ON”,
pressing the “Thread Cutter” button
automatically lowers the presser foot
(if it is raised) before cutting the thread.
The presser foot will be raised after the
thread is cut.
No. Key Name Explanation