Brother 882-W30, Operation Manuals

Page: 149 / 236

SEWING THE STITCHES
U
tili
ty
S
tit
ch
es
147
3
■
Darning
Use darning stitches for mending and other
applications.
Darning is performed by sewing from the front of the
presser foot to the back as shown below.
a Reinforcement stitches
a
Select a stitch, and attach buttonhole foot
“A+”.
b
Set the scale to the desired length of the
darning.
a
Presser foot scale
b Completed length measurement
c Width 7 mm (approx. 1/4 inch)
d 5 mm (approx. 3/16 inch)
c
Check that the needle drops at the desired
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
d
Gently hold the end of the upper thread,
and then press the “Start/Stop” button to
start the machine.

Once sewing is completed, the machine
automatically sews reinforcement stitches, and then
stops.
Stitch Stitch name Presser foot
Darning
Darning
Memo
• The maximum length for darning is 50 mm
(approx. 1-31/32 inches).
a
d
c
b
Note
• Pass the thread underneath the presser
foot.
• Set the presser foot so that there is no gap
behind the section marked with an “A+” (the
shaded area in the illustration below). If
there is a gap, the size of the darning will
not be correct.
Memo
• If automatic thread cutting is turned on
before you start sewing, both threads are
automatically cut after the reinforcement
stitches are sewn. If the fabric does not feed
(for example, because it is too thick),
increase the stitch length setting.