6
LI-PO BATTERY WARNING
This device contains a Lithium-Polymer battery . The battery must be recycled or disposed
of properly . Contact your local waste management office for information on battery
recycling or disposal .
Use only the supplied cable to recharge the battery . Improper charging may damage the
battery and the device .
Do not attempt to open the rechargeable battery or battery pack . There are no
serviceable parts inside .
Keep the battery out of reach of children . If swallowed, consult a physician immediately .
Do not hit, throw, or drop the battery on any hard surface .
Do not immerse the battery in water; keep in a dry, cool place .
Do not overcharge the battery . Charge for one hour or less . Monitor the charging process .
When storing the battery, store it with a partial charge . Do not store when fully charged or
depleted .
Do not expose the battery to high temperatures or dispose of battery in a fire as it may
explode . The battery may also explode if damaged .
BC
AA BATTERY PRECAUTIONS
Dispose of used batteries properly . Do not dispose of batteries in a fire .
Do not leave the batteries where a child or pet could play with or swallow them . If the
batteries are swallowed, contact a physician immediately .
The batteries may explode if mistreated . Do not attempt to recharge or disassemble the
batteries .
Use only fresh batteries of the required size and type . Do not mix old and new batteries,
different types of batteries, or rechargeable batteries of different capacities .
7
CHARGING THE BATTERY
Each drone uses a rechargeable Lithium-Polymer battery . Charge the batteries before
first use and when the battery is low, indicated by a flashing red LED on the controller .
To charge the batteries:
1 .
Ensure that the drones and the controllers are powered OFF .
2 .
On the bottom of each drone, press the Battery Release Latch away from the
Battery Brick to the unlocked position, then remove the Battery Brick . (See the
illustration on Page 8 for location of release lever and brick .)
3 .
Slide the Battery Brick into the charging unit . Ensure that the connector
is inserted properly, with the electronic connections matched .
4 .
Connect the USB connector to the USB port of an active device, such
as a computer or USB power adapter (not included) . While charging,
the red LED in the charging unit will be on and the yellow LED will be flashing . A
full charge takes approximately 80 minutes .
5 .
When the battery is fully charged, the green LED will be solid . Disconnect the
cable,
hold the Battery Release Latch in the unlocked position
, and reinsert the
Battery Brick into the drone .
NOTE: Do not leave unattended while charging. Do not charge overnight.
INSERTING THE CONTROLLER BATTERIES
Each controller uses 4 AA batteries (included) which must be inserted
before first use . To insert the controller's batteries:
1 .
Use the included screwdriver to remove the battery cover on the
back of each controller .
2 .
Insert 4 AA batteries, following the polarity indicators .
3 .
Replace the battery cover .
1.5V AA
1.5V AA
1.5V AA
1.5V AA
1.5V AA
1.5V AA
1.5V AA
1.5V AA
