10
LINK THE DRONES WITH THE CONTROLLERS
Before flying, each drone and controller pair must be linked and the gyroscopes must be
allowed to calibrate .
NOTE: It is important to perform the drone/controller link one pair at a time.
If
both drones are powered ON during the linking procedure they will both be linked to the
same remote and the second remote will be unable to link to either craft . If this occurs,
completely power OFF all of the equipment and perform the connection procedure again,
one pair at a time .
Begin with the drone and the controller powered OFF.
1 .
Ensure that the drone's battery has been fully charged and the controller's batteries
have been inserted (see Page 7) .
2 .
Slide the drone's Power switch to the ON position . The LED lights will blink as the
craft searches for a signal from the controller .
3 .
Place the drone on a flat, level surface . This is necessary for the drone's gyroscopes
to properly align .
4 .
Power the controller ON . The light on the controller will blink
as it searches for the signal from the drone . A tone will sound
when the controller and the drone have linked with each other .
5 .
Push the Left Control Stick (throttle) fully forward, wait for a
tone, then pull the stick fully back and wait for a second tone .
When this last tone has sounded the drone is ready to fly.
11
FLYING THE DRONE
After the drones and controllers have been linked, you are ready to fly the drones .
NOTE
:
Review the warnings and tips on Pages 3, 4, and 12 before flying.
1 .
Use the Left Control Stick to take off and control the
throttle and yaw (spin) movement of the drone .
2 .
Use the Right Control Stick to control the pitch (forward/
backward) and Roll (left/right) movement of the drone .
3 .
When you are done flying, land the drone, then pull the
Left Control Stick (throttle) fully back and wait for the rotors to stop spinning .
4 .
Important:
Power OFF the controller BEFORE powering OFF the drone.
This will
ensure that no signals are accidentally sent by the controller, reducing the chance of
injury . After the controller is powered OFF, it is safe to pick up the drone and remove
the battery .
Flight range (distance between drone and controller) is up to 100 feet (30 meters) .
SPEED SETTING
While the drone is on and not flying, press the Velocity
button to set the desired speed .
•
Low
: Provides smooth and predictable control of the
drone . One beep will confirm the setting .
•
High
: Highest setting for maximum performance .
Two beeps will confirm the setting .
ON
OFF
ON
OFF
ON
OFF
