Brocade Communications Systems ICX 7250 series, Configuration Manual

Page: 312 / 483

NOTE
All configuration for route reflection takes place on the route reflectors, not on the
clients.
Enter the following commands to configure a Brocade device as route reflector 1. To configure route reflector 2, enter the same
commands on the device that will be route reflector 2. The clients require no configuration for route reflection.
device(config-bgp)# cluster-id 1
Syntax: [no] cluster-id num | ip-addr
The num and ip-addr parameters specify the cluster ID and can be a number from 1 - 4294967295, or an IP address. The default is
the device ID. You can configure one cluster ID on the device. All route-reflector clients for the device are members of the cluster.
NOTE
If the cluster contains more than one route reflector, you need to configure the same cluster ID on all the route reflectors in the
cluster. The cluster ID helps route reflectors avoid loops within the cluster.
To add an IBGP neighbor to the cluster, enter the following command:
device(config-bgp)# neighbor 10.0.1.0 route-reflector-client
Syntax: [no] neighbor ip-addr route-reflector-client
Disabling or re-enabling client-to-client route reflection
By default, the clients of a route reflector are not required to be fully meshed. Routes from a client are reflected to other clients. However,
if the clients are fully meshed, route reflection is not required between clients.
If you need to disable route reflection between clients, enter the no client-to-client-reflection command. When this feature is disabled,
route reflection does not occur between clients does still occur between clients and non-clients.
device(config-bgp-router)# no client-to-client-reflection
Enter the following command to re-enable the feature.
device(config-bgp)# client-to-client-reflection
Syntax: [no] client-to-client-reflection
Configuring confederations
A confederation is a BGP4 Autonomous System (AS) that has been subdivided into multiple, smaller autonomous systems. Subdividing
an AS into smaller autonomous systems simplifies administration and reduces BGP4-related traffic, which in turn reduces the complexity
of the Interior Border Gateway Protocol (IBGP) mesh among the BGP4 devices in the AS.
The Brocade implementation of this feature is based on RFC 3065.
Normally, all BGP4 devices within an AS must be fully meshed, so that each BGP4 device has BGP4 sessions to all the other BGP4
devices within the AS. This is feasible in smaller autonomous systems, but becomes unmanageable in autonomous systems containing
many BGP4 devices.
When you configure BGP4 devices into a confederation, all the devices within a sub-AS (a subdivision of the AS) use IBGP and must be
fully meshed. However, devices use EBGP to communicate between different sub-autonomous systems.
Optional BGP4 configuration tasks
Brocade FastIron Layer 3 Routing Configuration Guide
312 53-1003903-04