Brocade Communications Systems ICX 7250 series, Configuration Manual

Page: 219 / 483

Virtual links
All ABRs must have either a direct or indirect link to the OSPFv2 backbone area (0.0.0.0 or 0). If an ABR does not have a physical link to
the area backbone, the ABR can configure a virtual link to another router within the same area, which has a physical connection to the
area backbone.
The path for a virtual link is through an area shared by the neighbor ABR (router with a physical backbone connection), and the ABR
requires a logical connection to the backbone.
Two parameters fields must be defined for all virtual links—transit area ID and neighbor router:
• The transit area ID represents the shared area of the two ABRs and serves as the connection point between the two routers. This
number should match the area ID value.
• The neighbor router field is the router ID (IP address) of the router that is physically connected to the backbone, when assigned
from the router interface requiring a logical connection. When assigning the parameters from the router with the physical
connection, be aware that the router ID is the IP address of the router requiring a logical connection to the backbone.
NOTE
By default, a device’s router ID is the IP address configured on the lowest numbered loopback interface. If the device does not
have a loopback interface, the default router ID is the lowest numbered IP address configured on the device. When you establish
an area virtual link, you must configure it on both of the routers (both ends of the virtual link).
Virtual links cannot be configured in stub areas and NSSAs.
The following figure shows an OSPF area border router, Device A, that is cut off from the backbone area (area 0). To provide backbone
access to Device A, you can add a virtual link between Device A and Device C using Area 1 as a transit area. To configure the virtual link,
you define the link on the router that is at each end of the link. No configuration for the virtual link is required on the routers in the transit
area.
FIGURE 21 Defining OSPF virtual links within a network
Virtual links
Brocade FastIron Layer 3 Routing Configuration Guide
53-1003903-04 219