Brocade Communications Systems ICX 7250 series, Configuration Manual

Page: 119 / 483

TABLE 19 CLI display of IP traffic statistics - Layer 3 switch (continued)
Field Description
out segments The number of TCP segments sent by the device.
retransmission The number of segments that this device retransmitted because the
retransmission timer for the segment had expired before the device at the
other end of the connection had acknowledged receipt of the segment.
RIP statistics
The RIP statistics are derived from RFC 1058, "Routing Information Protocol".
requests sent The number of requests this device has sent to another RIP router for all
or part of its RIP routing table.
requests received The number of requests this device has received from another RIP router
for all or part of this device RIP routing table.
responses sent The number of responses this device has sent to another RIP router
request for all or part of this device RIP routing table.
responses received The number of responses this device has received to requests for all or
part of another RIP router routing table.
unrecognized This information is used by Brocade customer support.
bad version The number of RIP packets dropped by the device because the RIP
version was either invalid or is not supported by this device.
bad addr family The number of RIP packets dropped because the value in the Address
Family Identifier field of the packet header was invalid.
bad req format The number of RIP request packets this router dropped because the
format was bad.
bad metrics This information is used by Brocade customer support.
bad resp format The number of responses to RIP request packets dropped because the
format was bad.
resp not from rip port This information is used by Brocade customer support.
resp from loopback The number of RIP responses received from loopback interfaces.
packets rejected This information is used by Brocade customer support.
Displaying IP information - Layer 2 switches
You can display the following IP configuration information statistics on Layer 2 switches:
• Global IP settings
• ARP entries
• IP traffic statistics
Displaying global IP configuration information
To display the Layer 2 switch IP address and default gateway, enter the show ip command.
device# show ip
Switch IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Default router address: 192.168.1.1
TFTP server address: None
Configuration filename: None
Image filename: None
Syntax: show ip
Displaying IP configuration information and statistics
Brocade FastIron Layer 3 Routing Configuration Guide
53-1003903-04 119