Brocade Communications Systems FastIron SX, Hardware Installation Manual

Page: 139 / 182

5. Release the latch on the front of the power supply to unlock the power supply from its position in the chassis:
• – Locate the 1/2 in tab (latch release) on the bottom center of the front of the power supply
– Firmly press on the latch release
– The latch should spring open
– Gently push the latch to the right
6. Carefully remove the power supply from the chassis.
7. Install a new power supply in the slot. For information about performing this task, refer to “Installing a new power supply”
section.
Installing a new power supply
You can order a new power supply from Brocade Communication Systems, Inc.
The procedures for installing a power supply differ depending on the power supply type (replacement or original). Be sure to refer to the
appropriate procedures in this section. For the differences between replacement and original power supplies, refer to the “Replacement
power supplies” sections.
DANGER
Before beginning the installation, see the precautions in “Power precautions.”
Installing a replacement power supply
For an overview of replacement power supplies (part numbers 32014-xxx and 32016-xxx), refer to the “Replacement power supplies”
section.
To install a replacement power supply, you need a Phillips-head or flathead screwdriver.
The following illustration shows the replacement power supplies.
Installing or replacing a power supply
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04 139