broag SEAGOLD 1A HR, Manual

Page: 135 / 259

Remeha Gas 350
6
Suitable chemicals and their use should be discussed
with a specialist water treatment company prior to car-
rying out any work. The specification of the system and
manufacturers recommendations must be taken into
account, along with the age and condition of the system.
New systems should be flushed thoroughly to remove all
traces of flux, debris, grease and metal swarf generated
during installation. Care to be taken with old systems to
ensure any black metallic iron oxide sludge and other
corrosive residues are removed, again by thoroughly
flushing, ensuring that the system is drained completely
from all low points.
NOTE:
Please ensure that the new boiler plant is not in
circuit when the flushing takes place, especially if clean-
sing chemicals are used to assist the process.
Under no circumstances is the boiler to be operated
with cleaning chemicals in the system.
To Summarise:
-
Minimise water loss;
- Prevent pumping over in open vented systems;
- Provide adequate air venting at all high points;
- Keep pH level between 7 - 9 when using additives;
- Maximum chlorine content of 200 mg/l;
Take advice on the suitability of inhibitors.
4.1.5 Noise level
The noise level measured around the boiler depending
on boiler room construction is about 50 dBA. Noise
levels taken at 1 meter from the boiler.
4.2 Chimneys
The average flue gas temperature is so low (108-
173°C) that the chimney must be made in accordance
with the guidelines of British Gas, BS 6644 and IG 10.
4.3 Installation standards
The following instructions must be adhered to when the
Remeha Gas 350 is installed:
Gas Safety (installation and use) Regulations 1984 (as
amended).
In addition to the above regulations, this boiler must be
installed in compliance with:
-
Current I.E.E. Regulations for electrical installations;
- Local building regulations;
- The Building Standards (Scotland);
- (Consolidation) Regulations;
- By-laws of the local water undertaking;
- Health and Safety Document No 635 ‘The Electricity
at Work Regulations 1989’.
It should also be in accordance with the relevant recom-
mendations in the current editions of the following British
Standards and Codes of Practice, viz. BS 5440 Pt 1 and
2, BS 5449, BS 5546,
BS 6798, BS 6891 and BG.DM2.
Lawfully all gas appliances must be installed by compe-
tent persons (e.g. Corgi, ACOPS).
Failure to install appliances correctly could lead to pros-
ecution.
It is in your own interest and that of safety to ensure that
the law is complied with.
Important:
The Remeha Gas 350 is a certified appliance and must
not be modified or installed in any way contrary to these
‘Installation and Servicing Instructions’. Manufacturer
instructions must NOT be taken in any way as when
overriding statutory obligations.