Briteq BT-SUNRAY 130R, Operation Manual

Page: 11 / 16

ENGLISH OPERATION MANUAL
BRITEQ
®
9/12 BT-SUNRAY 130R
OPERATING INSTRUCTIONS
Note:
when the projector is switched on the display shows “UPDATE WAIT …” This message informs you
that IF you want to upgrade the firmware, you should do it while this message is shown on the display. For
normal use you can ignore this message completely.
STANDALONE OPERATION
•
Connect the projector(s) to the mains.
•
Make sure that the option NO DMX BEHAVIOR in the setup MENU is set to: ST.ALONE
•
In the setup MENU select the option ST.ALONE and set the desired dimmer level.
•
If used in a quiet environment: select the option FAN and chose SILENT mode.
DMX OPERATION
•
Connect all units together. Refer to the
chapter “Electrical installation for two or more units in DMX-mode”
to learn how to do this (don’t forget to address all units properly!)
•
Connect all units to the mains and turn on the DMX controller.
•
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
can use a different number DMX-channels, depending on the DMX-mode you have selected in the MENU.
BLIND BLIND EXPO EXPO DMX
FUNCTION REMARKS
8b 16b WW DTW VALUES
1 1 1 1
000-255 DIM WHITE coarse
See control channel for RED SHIFT
2
000-255 DIM WHITE fine
2 3
000-255 DIM AMBER coarse RED SHIFT ACTIVE: not used
4
000-255 DIM AMBER fine
RED SHIFT ACTIVE: not used
3 5
STROBE CHANNEL
000-007 Open (no strobe)
008-126 Random strobe (slow→fast)
127-131 Open (no strobe)
132-250 Normal strobe (slow→fast)
251-255 Closed (no output)
4 6
CONTROL CHANNEL
000-005 RED SHIFT (amber drift) ACTIVE NO 3s delay used !
006-010 RED SHIFT (amber drift) OFF
NO 3s delay used !
011-026 No function
027-127 DIMMER SPEED: (0,0s → 1,5s)
selected after 3 sec
128-151 No function
152-157 FAN SILENT: temp. controlled, low speed selected after 3 sec
158-161 FAN AUTO: temp. controlled, high speed
selected after 3 sec
162-167 No function
168-173 LINEAR dimmer curve
selected after 3 sec
174-179 SQUARE dimmer curve selected after 3 sec
180-185 INVERSE SQUARE dimmer curve selected after 3 sec
186-191 S-CURVE dimmer curve selected after 3 sec
192-255 No function