Briteq BT-SUNRAY 130R, Operation Manual

Page: 5 / 16

ENGLISH OPERATION MANUAL
BRITEQ
®
3/12 BT-SUNRAY 130R
DESCRIPTION:
1. MAINS INPUT: equipped with original Neutrik PowerCON
®
. Connect the supplied mains cable or any
PowerCON ® extension cable here.
2. MAINS OUTPUT: used to daisy chain the power to several other projectors. Always pay attention to the
maximum load while adding projectors! Special Multi cables (PowerCON
®
+ DMX XLR-cables are
optionally available: see our website!)
3. AIR PRESSURE VENT: for improved performance and service life, this special vent equalizes the
pressure inside the projector while blocking water and preventing condense from being formed.
4. DMX IN: 3pin XLR connector used to connect the projector with other units or a DMX-controller. The
DMX-input is also used to update the firmware of the projector, see the upgrade instructions on our
website.
5. DMX OUT: 3pin XLR connector used to daisy chain the projector with other units.
Remark: a separate modification kit (
“BT-XLR3TO5 KIT” order code: 5523) is available to easily change
the current 3pin XLR-connectors into 5pin XLR-connectors: this takes only 2 minutes!)
6. DISPLAY & BUTTONS: alphanumeric OLED-display and backlit touch keys to select different options of
the setup MENU:
•
MENU-button: used to enter/exit the setup MENU.
•
▼-button:
used to go to the next MENU option or to decrease a parameter value.
•
▲-button:
used to go to the previous MENU option or to increase a parameter value.
•
ENTER-button: used to select a MENU option or confirm a setting.
Remark: to rotate the display
over 180°, press the ▲-button while the standard display is shown.