ENGLISH
OPERATION MANUAL
BRITEQ
®
6/12
BT-SUNRAY 130R
FAN
Used to set the working mode of the cooling system.
•
Use the
▼/▲ buttons to browse the MENU until the required function shows up.
•
Select the function with the ENTER-button.
•
Use
▼/▲ buttons to select the desired mode:
•
SILENT
The fans are temperature controlled, low fan speed for use in a quiet location.
Note that the light output is reduced when the LED temperature becomes too high.
•
AUTO
The fans are temperature controlled, high fan speed for increased cooling.
•
Once the correct option shows on the display, press the ENTER-button to save it.
Remark: this option can be overruled using the DMX-control channel.
TEMP
Used to show the temperature of the LEDs.
•
Use the
▼/▲ buttons to browse the MENU until the required function shows up.
•
Select the function with the ENTER-button.
•
Use
▼/▲ buttons to select the desired mode: °C / F
DEFAULT SETTINGS
Used to quickly select the basic settings for BLINDER or EXPO functions
•
Use the
▼/▲ buttons to browse the MENU until the required function shows up.
•
Select the function with the ENTER-button.
•
Use
▼/▲ buttons to select the desired mode:
•
BLINDER:
most obvious settings for use as a BLINDER
•
EXPO:
most obvious settings for use as an EXPO projector
•
Once the correct option shows on the display, press the ENTER-button to save it.
PARAMETER name
BLINDER mode defaults
EXPO mode defaults
CHANNEL mode
BLIND 8b
EXPO WW
NO DMX mode
BLACKOUT
ST.ALONE
DIM Curve
Square
Square
Dimmer Speed
100 (440ms)
100 (440ms)
FAN Set
Auto
Silent
Backlight
1 min.
1 min.
AUTO LOCK MENU
OFF
OFF
no DMX blink display
ON
OFF
Temp C/F
Celcius
Celcius
FIRMWARE VERSION
Used to show the current version of the firmware.
•
Use the
▼/▲ buttons to browse the MENU until the required function shows up.
•
Select the function with the ENTER-button: the current firmware version is shown.
Note: The firmware of this unit can be upgraded using our specia
l “Firmware Updater 2” (separately
available from Briteq
®
). More information about this can be found in the user manual of the firmware updater
or our website: https://briteq-lighting.com/firmware-updater-2
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
Locate the fixture in a well ventilated spot, far away from any flammable materials
and/or liquids. The fixture must be fixed
at least 50cm
from surrounding walls.
•
The device should be installed out of reach of people and outside areas where persons
may walk by or be seated.
•
Before rigging make sure that the installation area can hold a minimum point load of
10times the device’s weight.
Summary of Contents for BT-SUNRAY 130R
