Briteq BT-SUNRAY 130R, Operation Manual

Page: 7 / 16

ENGLISH OPERATION MANUAL
BRITEQ
®
5/12 BT-SUNRAY 130R
DIMMER CURVE
Used to set the dimmer curve of the individual pixels.
•
Use the
▼/▲ buttons to browse the MENU until the required function shows up.
•
Select the function with the ENTER-button.
•
Use
▼/▲ buttons to select the desired curve:
•
Once you selected the desired curve, press the ENTER-button to save it.
Remark: this option can be overruled using the DMX-control channel.
LOCKING MODE
Used to lock the setup MENU against
unwanted altering of the settings.
•
Use the
▼/▲ buttons to browse the
MENU until the required function shows
up.
•
Select the function with the ENTER-
button.
•
Use
▼/▲ buttons to select the desired
mode:
•
OFF: The setup MENU can be used
at any time.
•
ON: After a short time the setup
MENU locks automatically, the
display shows LOCKED ***** .

Unlock the display by pressing
the buttons in this order:
▲, ▼,
▲, ▼, ENTER
.
•
Once the correct option shows on the
display, press the ENTER-button to save
it.
NO DMX BEHAVIOR
Used to set how the projector reacts
when
the DMX-signal suddenly
disappears.
•
Use the
▼/▲ buttons to browse the
MENU until the required function shows
up.
•
Select the function with the ENTER-
button.
•
Use
▼/▲ buttons to select the desired
mode:
•
BLACKOUT: output turns black
while no DMX is detected.
•
FREEZE: output based on the last
valid DMX-signal is kept on the projector.
•
ST.ALONE: light output depends on dimmer value in the ST.ALONE option.
•
Once the correct option shows on the display, press the ENTER-button to save it.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.