ENGLISH
OPERATION MANUAL
BRITEQ
®
5/55
BT-BEAM70
Press the ENTER button, the display starts blinking.
Use DOWN and UP button to select “Yes” (Split colors) or “No” (only
full colors).
Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Slave Mode
Used to make the slave unit work in opposite to the master or to
work in complete sync.
Press the MENU button until
“Slave Mode” is shown on the display.
Press the ENTER button, the display starts blinking.
Use DOWN and UP button to select Slave1 (normal) or Slave2 (2 light
show) mode.
Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in
blackout and waits for the DMX-signal.
No blackout mode: when no DMX-signal is detected, the unit
automatically switches to standalone mode.
Press the MENU button until “Black Out” is shown on the display.
Press the ENTER button, the display starts blinking.
Use DOWN and UP button to select
“Yes” (blackout on) or “No”
(blackout off) mode.
Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Sound State
The unit works to rhythm of the beat when used in standalone or
master/slave mode
Press the MENU button until
“Sound State” is shown on the display.
Press the ENTER button, the display starts blinking.
Use DOWN and UP button to select
“On” or “Off” mode.
Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Sound Sense
Used to set the sensitivity of the internal microphone
Press the MENU button until “Sound Sense” is shown on the display.
Press the ENTER button, the display starts blinking.
Use DOWN and UP button to select a value between “0” (very low
sensiti
vity) and “100” (high sensitivity).
Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
