8
Basin Taps - Installation
Push-fit
connector
Back nut
with rubber
seal
‘O’ ring
Under
the
basin
10mm
hexagonal
key
Cover cap
Flexible
connecting
pipe
Locating
pin
Before installation
Flush through the pipework to ensure
removal of debris. Turn off mains water
supply and close any isolating valves.
1. Attach push-fit connectors
Place the ‘push-fit connectors’ into the
holes in the basin top, ensure the rubber
‘O’ ring is fitted to the underside.
Position the ‘back nuts’ under the basin
(with rubber seal on top), ensuring the
locating pin fits into the cut-out in the
back nuts. Tighten by turning the 10mm
hexagonal key clockwise, once threading
has started you can let go of the back nuts.
Important:
The push-fit connectors
must be fully tightened to the back nuts
before attaching the flexible connecting
pipes.
2. Attach flexible connecting pipes
Important:
Before connecting the
flexible connecting pipes, please refer to
the specific installation requirements on
page 6.
Carefully screw the ‘flexible connecting
pipes’ into the ‘push-fit connectors’ and
turn the integral isolation valves to the
'closed' position as shown on page 6.
Important:
Only tighten the flexible
connecting pipes by hand.
Do not
overtighten.
Connect the flexible connecting pipes to
the household water supply pipes.
3. Cover cap
If required place the cover caps over the
push-fit connectors until the tap body is
ready to be fitted.
