16
5. Fit the tap body
Remove the cover cap and grease the
push-fit connector using the sachet of
grease provided. Push-fit the tap body onto
the connector.
Align the body and tighten both grub
screws at the rear of the body using the
long end of the 2.5mm hexagonal key as
shown below until finger tight. Remove
the hexagonal key and insert the short
end into the grub screw and tighten an
extra ¾ to 1 complete turn more to ensure
the tap body is securely tightened to the
push-fit connector.
Important:
The fitting must be
securely attached to the base.
X 2 Grubscrews
Turn on the mains water supply and
open the isolating valves using a suitable
flatblade screwdriver.
Operation
Moving the lever up/down will increase/
decrease the flow of water.
Moving the lever either right to left
will increase or decrease the water
temperature.
Basin Mixer Tap - Installation
Cold
Hot
Increase flow
2.5mm
hexagonal key
Push-fit connector
