Brink Renovent Sky 200, Installation Instructions Manual

Page: 13 / 48

5.1 Installation general
Installation must take place under:
‡ 4XDOLW\UHTXLUHPHQWVYHQWLODWLRQV\VWHPVGZHOOLQJV
‡ 4XDOLW\UHTXLUHPHQWVEDODQFHGYHQWLODWLRQLQGZHOOLQJV
‡ 7KH UHJXODWLRQV IRU YHQWLODWLRQ RI GZHOOLQJV DQG UHVLGHQWLDO
buildings.
‡ 7KHVDIHW\UHJXODWLRQVIRUORZYROWDJHLQVWDOODWLRQV
‡ 7KH UHJXODWLRQV IRU FRQQHFWLRQ WR LQWHULRU VHZHUV LQ GZHOO
-
ings and residential buildings.
‡ $Q\DGGLWLRQDOUHJXODWLRQVRIWKHORFDOXWLOLWLHV
‡ 7KHLQVWDOODWLRQLQVWUXFWLRQVIRUWKH5HQRYHQW6N\
‡
In addition to the above design and installation requirements
and recommendations, the national building and ventilation
regulations must be complied with.
Renovent Sky 200 Rev. C 9
Chapter 5 Installation
3ODFLQJWKHDSSOLDQFH
The Renovent Sky 200 can directly be mounted to the wall or
ceiling using the mounting brackets supplied for that purpose.
%HFDXVHRIWKHDSSOLDQFH¶VZHLJKWPRXQWLQJWKH
appliance must always be done by two people!
The Renovent Sky can directly be mounted to the wall/ ceiling
using the suspension brackets supplied for that purpose. For a
vibration-free result the appliance must be mounted to a solid
wall with a minimum mass of 200 kg/m
2 . A gypsum block or
PHWDOVWXGZDOOGRHVQRWVXI¿FH$GGLWLRQDOPHDVXUHVVXFKDV
double panelling or extra studs are required in that case. In ad-
dition, the following aspects must be taken into account.
‡ 7KHDSSOLDQFHPXVWEHSODFHGOHYHO
8
9
9
8
8 8
9
9
9
‡
The installation room must be such that a good conden-
sate discharge with air trap and pitch for condensate can
be made.
‡ :H UHFRPPHQG QRW WR LQVWDOO WKH KHDW UHFRYHU\ XQLW LQ
spaces with an average high RH (for instance bathroom).
That will prevent condensation on the outside of the heat
recovery unit.
Make sure that under no condition the condensate
discharge is installed at a pitch towards the appli-
ance!
The appliance is only suitable for ceiling or wall
PRXQWLQJ1HYHUPRXQWWKHDSSOLDQFHÀDWRQWKH
ÀRRU EHFDXVH RI WKH SRVLWLRQ RI WKH FRQGHQVDWH
discharge bin!
‡
The heat recovery unit must be installed in an insulated,
frost-free room to prevent, among other things, freezing of
the condensate discharge
‡ :KHQPRXQWLQJÀH[LEOHGXFWVEHDULQPLQGWKDWLWPXVWEH
possible to replace them in due course.
‡ 0DNHVXUHWKHUHLVVXI¿FLHQWIUHHVSDFHDWWKHDSSOLDQFHWR
DOORZFOHDQLQJRIWKH¿OWHUVDQGPDLQWDLQLQJWKHDSSOLDQFH
It must be possible to swing the door open.
‡ $YRLG WKH XVH RI SHWUROHXPEDVHG DGKHVLYHV LQ DLU SODQW
systems.
‡ 'ZHOOLQJV ZLWK FRQVWUXFWLRQ PRLVWXUH PXVW EH YHQWLODWHG
QDWXUDOO\GXULQJDFHUWDLQSHULRG
Ceiling mounting:
At least 70 cm at the underside of the appliance and a free
headroom of 1.8 m; if 70 cm free space is not available,
for instance when mounting on top of a suspended ceiling,
WKHUHPXVWEHVXI¿FLHQWURRPWRSDUWO\RSHQDQGUHPRYH
the front panel.
The front panel can be detached after removing a lock
screw at the hinge!
(§ 3.4 / nr. 6)
0DNH VXUH WKH ¿OWHUV FDQ DOZD\V IUHHO\ EH UHPRYHG VR
WKHUHLVQRIUDPHRURWKHUREVWDFOHDWWKHOHYHORIWKH¿OWHUV
Wall mounting :
Make sure there is a free space of at least 70 cm at the
front of the appliance and a free headroom of 1.8 m.
‡ 0DNHVXUHWKHUHLVDWOHDVWFPIUHHVSDFHDWWKHDSSOL
-
ance side where the electric connections are located, so
connectors and sleeves remain accessible.
Air ducts:
‡ 7KHDLUGXFWVPXVWEHPRXQWHGDLUWLJKW
‡ 7KHDLUGXFWVWRDQGIURPWKHGZHOOLQJPXVWEH¿WWHGZLWKD
PXIÀHU
‡ 0RXQWLQJRIDLUGXFWVWRWKHURRIGHFNPXVWEHDYRLGHGLQ
order to prevent sound transmission.
‡ ,WLVUHFRPPHQGHGWRUHVWULFWWKHH[WHUQDOGXFWSUHVVXUHLQ
WKHGHVLJQWR3DDWWKHGHVLJQÀRZUDWHLQRUGHUOLPLW
the total sound level. In all events the practical external
duct pressure must be limited to 150 Pa
‡ 7KHDLUYHORFLW\PXVWEHOLPLWHGWRPVLQWKHPDLQGXFWV
and 3,5 m/s in the branches.