Brew Monk 057.700.30, Instruction Manual

Page: 34 / 134

34
EN - Instruction Manual Brew Monk
2.5.2.1 During MASHING and BOILING
1. When 1 st step is finished, there is an audio signal (reminder ringing), programme
will not proceed with the 2
nd
step unless you press the AUTO button to confirm.
It is the ingredients filling reminder.
2. The boiling reminder is same as above, when machine finishes the step before
boiling, there is an audio signal (reminder ringing). The programme will not
proceed with the boiling step unless you press the AUTO button for
confirmation. It is the sparging reminder.
3. PAUSE button will stop the Brew Monk and timer working temporarily, and you can
modify the data, afterwards press AUTO to continue.
4. If you press the START button when auto mode is running, this will skip the
current step.
5. If you press the STOP button to skip all the steps, the machine stops working,
display shows END , bell rings for 30 seconds. Press the STOP button again enter
to BLANK PAGE .
2.5.2.2 Memory Function in Auto Mode
1. After setting all the data you need in auto mode, press STOP button until BLANK
PAGE . Please do not switch off the machine! Follow the steps below for recording.
2. Press MANUAL button to enter manual edit page, then press MANUAL button
5 seconds long, then release it. You can record the last manual and auto mode
setting. There is an audio signal (ringing bell) for successful recording.
3. Switch off/on the machine, then press AUTO button, the 1
st
step of last chosen
programme will be shown on the display.
4. Press START button, machine starts working.
5. Our programme does not support batch storage. For each entry, you need to
repeat the instructions above.
2.5.2.3 Input/Changing Memory Function for Auto Mode
When in BLANK PAGE , simultaneously press POWER and TIMER buttons for 5 seconds.
The display will enter into recipe selection. Press “ - ” or “ + ” to choose required recipe
(R0S1, R1S1, ...). Recipe storage is up to 10 programmes. Press START button to confirm
the selected recipe,
BLANK PAGE
will be shown on display, then press
AUTO/PAUSE
button to enter the selected recipe edit page. You can press START button to run
the selected programme instantly or press AUTO/PAUSE button to edit/check
the programme step by step.