14
Chapter 1: Hardware insertion.
Bed
Left Side
Right Hutch
Left Side
A
B B
A
Baseboard Notch
Panel Front
Bottom
Bottom
1812
"
16"
Panel Front
FIG. 1C
Green Boxed Areas:
BredaBeds Murphy
Beds are designed for a mattress
thickness of 11” or under, however
this area is adjustable for mattress
thicknesses greater than 11” if needed.
Use only 1 cam screw per box (2 total)
from Hardware Package #1:
• Holes ‘
A
’ (closest to panel midpoint)
are for mattresses up to 11” thick.
• Holes ‘
B
’ (hole closest to panel edge)
are for 11” to 13” thick mattresses.
Even though we provide this adjustment,
we highly recommend using a
mattress that is 11” or under so that
the headboard will sit at an angle to
minimize the gap between the wall and
the mattress.
Thus we recommend using holes ‘
A
’.
Purple Boxed Areas:
These areas
are for attaching the Bottom Nailer
later during assembly, which can be
adjusted if necessary, e.g.: low outlets.
Use only 2 cam screws per box (4
total) from Hardware Package #1 at
the dimensions listed. If later during
assembly you need to adjust the Bottom
Nailer, just make sure to keep one empty
hole between the two holes you use.
Using “
Bed Left Side” and the reverse side of “Right Hutch
Left Side”, insert cam screws from hardware package #1 in
holes marked with a
red
circle using a cordless drill.
STEP 3
